brewgaq.blogg.se

1. #Led fan editor software brookstone how to
2. #Led fan editor software brookstone mac os x
3. #Led fan editor software brookstone portable
4. #Led fan editor software brookstone download

I recently received a Brookstone Message Fan with Floating LED Display as a gift.

Double click on the LedFan Editor Icon to start the program.

#Led fan editor software brookstone mac os x

Led Fan Editor Software — led-fan-editor) is a Mac OS X software application that has been discovered and submitted by users of iBoostUp.

#Led fan editor software brookstone download

And is available for download at the sourceforge led-editor page. Usb Fan Led, free usb fan led software downloads.

#Led fan editor software brookstone portable

fce566e3ea 16 USB Fan with LED Display, SAYTAY Small Personal Portable Programmable LED Fan, Funny USB Toy…. The following page contains the schematic, . The first thing I tried to do was read the data stored on the EEPROM.This project makes it possible to switch 8 LEDS over a USB connection. For the CAT24C04, the a8 bit is 0 for bytes 0-255 of the EEPROM, and 1 for bytes 256-511. Those pins were connected to ground, so both values were zero. The first 4 bits are fixed, and then A2 and A1 are determined by the state of the corresponding pins.

#Led fan editor software brookstone how to

The table below (from the EEPROM datasheet) shows how to figure out the I2C slave address. The smaller EEPROMs can address their entire memory in a single byte, but the 4kbit (and larger) versions require part of the device address for the higher values. The 512 byte version leaves the A0 pin unconnected and that bit in the EEPROM slave address is reserved for the high bit of the memory address. This software is capable of showing you even the hard disk temperature. I'm assuming they use the same fan PCB with the smaller EEPROMs and use the other address bit for some reason. The most popular Windows fan speed software available for free, quickly, it has a user-friendly interface and allows you to monitor and control not only the speed of your computer fan but also the voltages and the temperatures in your computer. The PA0 pin threw me for a little bit, but it is connected to what would be the A0 address pin on the EEPROM for smaller chips in the same line. On the back side of the PCB, the 5 pin port was labeled:, and I confirmed that these pins were connected to the I2C SDA and SCL pins on the EEPROM. Whatever microcontroller is being used is under a black blob, but the SOIC-8 IC with a marking on it was a, which is a 4kbit (512 byte) I2C EEPROM. This was a very simple project, but it was fun to figure out how something worked and then make it do something else. I searched online and found that were re programmable, but those had 4 buttons for programming in messages, and mine only has an on/off button. The box it came in says 'Programmable Message Fan: Model 45 Series'. The fan itself is pretty cool.but I wanted to see if I could make it say something else. The fan has clear, flexible plastic blades, and one of the blades has a strip of 7 LEDs in it which are used to display the messages. The company where I work has recently been doing a big push for safety, and last week they passed out small POV fans with sayings like, “Thx 4 Being Safe”, “Being Safe is Cool”, “I'm a Safety Fan”, etc. Led (LDAP Editor) Led is a general purpose LDAP editor which allows editing of LDIF records or standard unix flat file. Once the file is extracted you will see the LedFan.exe. Click on the 'Digital Fan Software' link The downloaded file is a 'ZIP' file.